RSS What is this?

central pneumatic Air Compressor Manuals

Choose from our list of products below:

    Don't See the Model Number Listed?
    Ask the membership for help locating your missing manual.

    Member Discussion on central pneumatic 47065 Air Compressor

    Please help find the manual for this Harbor Freight Tools Air Compressor

    shutting off when in use.

    Add a comment   |  Get This Manual

    Comments

    • File uploaded

      Good Luck, I hope this helps
      CSM Robbibaro
      USA (ret)


      Was this comment useful?

    • central pneumatic Air Compressor 47065

      I also have a problem with 47065 air compressor, which is shutting off when in use. I can press the reset switch and it runs again for a little while (and then shuts off again). Any suggestions?

      Was this comment useful?

    • Keeps shutting off

      Did you find the answer to the compressor's problem. I have the same issue with mine.

      Was this comment useful?

    • 47065 compressor shutting off

      alinbuckeye,
      Not 100% sure yet, but might have fixed my 47065 compressor. At first, I thought maybe the motor was overloading or getting too hot, but it didn't seem to be.
      So, I decided to try to unplug the breaker/overload switch on the side of the compressor. When I pulled on the two wires slightly, the wires pulled out from the spade terminal connectors (seems like they were not crimped on very good). I then noticed the spade connectors were soldered to the overload switch. So, I used a small screwdriver to pry open the ends of the spade terminal connectors and re-crimped the wires back into those ends. Now, when I run the compressor, it does not shut off. Could it have been poor connections to the overload switch? I am not 100% sure yet, but I ran it for about 20-30 minutes this morning, with no shut-off problems. Before, it would randomly shut off within a few minutes, time after time.
      I will post another message, if it starts acting up again.

      Was this comment useful?

    • compressor #47065 overheating

      I have a problem with the Central Pneumatic compressor # 47065 overheating when it is filling the tank. It has gotten so hot that it has melted the plastic muffler. I have checked and re-checked the oil level. All is correct. I have taken the piston apart but I don't know what to look for any way. Does anyone have any suggestions? The compressor is about 4 years old and worked for a couple of years.

      Was this comment useful?

    • Manual

      I tried to download the manual but couldn't. Would you please replace the link for it? Thanks, Wes

      Was this comment useful?


    Add Comment


    (optional)

    If you have a helpful URL, add it here.
    Product Picture:
    (optional)

    Supported file types: .jpg, .gif, .png
     

    Register now to download manuals, solve product problems, read blogs and newsletters, and get a free personal homepage

    Recent User Activity



    About OwnerIQ | Advertise | Manufacturers | Terms and Conditions | Privacy Policy