Agilent Technologies 81642A Stud Sensor User Manual


 
Getting Started with Tunable Laser Sources Optical Output
28 Agilent 81480A and 81680A, 40A, 82A, 42A, & 89A Tunable Laser Modules Users Guide,
Sixth Edition
Two additional connector interface options are available for the
Agilent 81689A Tunable Laser module:
Option 021, Standard single-mode fiber straight contact connectors,
or
Option 022, Standard single-mode fiber angled contact connectors.
CAUTION If the contact connector on your instrument is angled, you can only
use cables with angled connectors with the instrument.
Figure 12 Angled and Straight Contact Connector Symbols
Figure 12 shows the symbols that tell you whether the contact
connector of your Tunable Laser module is angled or straight. The
angled contact connector symbol is colored green.
Figure 7 and Figure 13 show the front panel of the Agilent 81682A
Tunable Laser module with straight and angled contact connectors
respectively.
You should connect straight contact fiber end connectors with neutral
sleeves to straight contact connectors and connect angled contact fiber
end connectors with green sleeves to angled contact connectors.
NOTE You cannot connect angled non-contact fiber end connectors with
orange sleeves directly to the instrument.
Figure 13 Agilent 81682A Tunable Laser Module (angled contact connector)
See “Accessories” on page 31 for further details on connector
interfaces and accessories.
Straight Contact
Connector Symbol
Angled Contact
Connector Symbol