Filter
Top Products
344 Chapter5
One-Button Measurement Functions
Mode Setup (Spectrum Analysis Mode)
One-Button Measurement Functions
Key Path: Mode Setup
Factory Preset: Off
History: Added with PSA firmware revision A.04.00
Remote Command:
[:SENSe]:RADio:STANdard:RPARams[:STATe]ON|Off|1|0
[:SENSe]:RADio:STANdard:RPARams[:STATe]?
Example: RAD:STAN:RPAR Off
5.3.4 Enable All Measurements
Allows you to specify whether all measurements and radio standards are enabled (set to
Yes) or not (Set to No).
NOTE Enable All Measurements willbedisabled(greyedout)ifameasurementis
entered when Enable All Measurements is set to Yes and the measurement
entered does not support the currently selected Radio Std. “Select a valid
radio standard/measurement combination to enable.” will be displayed.
Key Path:
Mode Setup
Factory Preset: No
History: Added with PSA firmware revision A.04.00
Remote Command:
[:SENSe]:RADio:STANdard:EAMeas YES|NO
[:SENSe]:RADio:STANdard:EAMeas?
Example: RAD:STAN:EAM YES
5.3.5 Autorange of Power Setting (Remote command only)
This command is the remote version of the Optimize Ref Level key. If this function is
applicable to the currently selected measurement, this command sets the reference level
and attenuator to optimum values based on the signal present at the input.
NOTE There is always a minimum of 6 dB of attenuation set to protect the analyzer
input.
History: Added with PSA firmware revision A.02.00