Filter
Top Products
14
USING THE TOOL
PROTECTIVE COVER INSTALLATION
CAUTION!
The protective cover should be used to prevent the dust and fl ying debris from hitting the
operator or from going inside the tool. Failure to do so can shorten the life of the tool and
void the limited warranty.
1. Slide the protective cover onto clamping collar so that
the lip on the protective cover fi ts into the groove on
the tool.
2. Position the protective cover with the shield facing
backwards as shown in Figure 6. Push down until
the protective cover is fi rmly seated on the clamping
collar.
3. Tighten the clamping screw to a snug
fi t. The protective cover should not be
able to move.
Groove
Figure-5
Figure-6
Figure-7
Figure-8