APC 2200 VA Battery Charger User Manual


  Open as PDF
of 2
 
Installation Guide SMT 2200/3000 VA
Optional Replacement PDU
Safety
Adhere to all national and local electrical codes. A certified electrician must perform all
electrical connections.
1. Disconnect equipment connected to the UPS.
2. Press the OFF button located on the front of the UPS.
3. Disconnect the batteries in the UPS.
4. Disconnect the UPS from utility power.
Installation
Note: The illustrations in this manual may differ slightly in appearance from the actual
hardware.
Remove the five screws that secure the factory
installed PDU panel to the UPS. Save the screws.
Disconnect the PDU output cables as shown in the
diagrams.
Do not disconnect the AC input connector.
su06695a
A
C Input Connector