Banner American Products R150-3M Work Light User Manual


  Open as PDF
of 2
 
LED..I150-3.. Low-Angle LED Ring Lights (150 mm)
Non-Diffused Lighting for Increased Close-Up Contrast
Printed in USA 11/06 P/N 127582 rev. A
Features
• 150 mm LED ring light for low-angle illumination. See Banner’s website at
www.bannerengineering.com for a complete lighting tutorial.
• Uses 3 tiers of LEDs mounted at 75° to the optical axis.
• Low-angle light enhances contrast of surface defects, etching, and embossed marks.
• Well suited for dot-peened or pin-stamped data matrix marks.
• Solid-state LED light source.
• Continuous or strobed operation is selectable via sensor software.
• Black anodized aluminum housing with ¼ - 20 threaded mounting holes.
• The suggested field of view is 80 mm in diameter and the suggested stand off
is 12.5 mm.
Models
Models* Illumination Color Cable/Connector
Supply Voltage
and Current
LEDRI150-3W
High-intensity,
low-angle light
Visible Red
640 nm
3-conductor, 2 m (6.5')
attached cable with flying
leads (see wiring table)
24V dc ±10% @ 500 mA max.
LEDII150-3W
Infrared
880 nm
24V dc ±10% @ 350 mA max.
LEDRI150-3M
Visible Red
640 nm
2 m (6.5') pigtail with
3-pin, 8 mm male
Pico-style connector
(direct connection to
PresencePLUS P4)
24V dc ±10% @ 500 mA max.
Voltage supplied by PresencePLUS sensor,
if operating at 24V dc (see sensor manual).
LEDII150-3M
Infrared
880 nm
24V dc ±10% @ 350 mA max.
Voltage supplied by PresencePLUS sensor,
if operating at 24V dc (see sensor manual).
*For 9 m (30') cable, add suffix “W30” to the model number (e.g., LEDRI150-3W W30).
Specifications
Useful Life When operated within specification, output will decrease less than 20% after 20,000 hours and less than 30%
after 30,000 hours.
NOTE: Actual useful life of strobed lights depends on duty cycle.
Environmental Rating IEC IP0; NEMA 0
Operating Conditions Temperature: 0° to +50° C (+32° to 122° F)
Maximum relative humidity: 90% at 50° C (non-condensing) max.
Cleaning Instructions Regularly remove any dust and dirt from the light source. Blow off dust using anti-static compressed air.
Certifications