Open as PDF
IMPORTANT SAFETY INSTRUCTIONS
FOR BATTERY CHARGERS
SAVE THESE INSTRUCTIONS: This
manual contains important safety
instructions for battery chargers.
• Before using charger, read all instructions
and cautionary markings on charger, battery
pack, and product using battery pack.
WARNING: Shock hazard. Do not
allow any liquid to get inside charger.
CAUTION: Burn hazard. To reduce
the risk of injury, charge only designated
BLACK+DECKER batteries. Other types of
batteries may burst causing personal injury
CAUTION: Under certain conditions,
with the charger plugged in to the power
supply, the charger can be shorted by
foreign material. Foreign materials of a
conductive nature such as, but not limited
to, steel wool, aluminum foil, or any buildup
of metallic particles should be kept away
from charger cavities. Always unplug the
charger from the power supply when there
is no battery pack in the cavity. Unplug
charger before attempting to clean.
WARNING: DO NOT attempt to
charge the battery pack with any chargers
other than the ones in this manual. The
charger and battery pack are specically
designed to work together.
• These chargers are not intended for any
uses other than charging designated
batteries. Any other uses may result in
risk of re, electric shock or electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when
disconnecting charger. This will reduce
risk of damage to electric plug and cord.
• Make sure that cord is located so that it
will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
• Do not use an extension cord unless it
is absolutely necessary. Use of improper
extension cord could result in risk of re,
electric shock, or electrocution.
• When operating a charger outdoors,
always provide a dry location and use
an extension cord suitable for outdoor
use. Use of a cord suitable for outdoor
use reduces the risk of electric shock.
• An extension cord must have adequate
wire size (AWG or American Wire Gauge)
for safety. The smaller the gauge number
of the wire, the greater the capacity of the
cable, that is 16 gauge has more capacity
than 18 gauge. When using more than one
extension to make up the total length, be
sure each individual extension contains at
least the minimum wire size.
Calibre mínimo para cables de extensión
Longitud total del cable en pies
120V 0-25 26-50 51-100 101-150
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
Más No más American Wire Gage
0 - 6 18 16 16 14
6 - 10 18 16 14 12
• Do not place any object on top of the
charger or place the charger on a soft
surface that might block the ventilation
slots and result in excessive internal
heat. Place the charger in a position
away from any heat source. The
charger is ventilated through slots in the
top and the bottom of the housing.
• Do not operate charger with damaged
cord or plug — have them replaced
• Do not operate charger if it has
received a sharp blow, been dropped,
or otherwise damaged in any way. Take
it to an authorized service center.
• Do not disassemble charger; take it
to an authorized service center when
service or repair is required. Incorrect
reassembly may result in a risk of electric
shock, electrocution or re.
• Disconnect the charger from the outlet
before attempting any cleaning. This
will reduce the risk of electric shock.
Removing the battery pack will not
reduce this risk.
• NEVER attempt to connect 2 chargers
• The charger is designed to operate on
standard household electrical power
(120 Volts). Do not attempt to use it on
any other voltage.
SAVE THESE INSTRUCTIONS
INSTRUCTION FOR BATTERY
WARNING: For safe operation, read
this manual and manuals originally supplied
with tool before using the charger.
The battery pack is not fully charged out of
the carton. Before using the battery pack and
charger, read the safety instructions below.
Then follow charging procedures outlined.
READ ALL INSTRUCTIONS
• Do not incinerate the battery pack
even if it is severely damaged or is
completely worn out. The battery pack
can explode in a re. Toxic fumes and
materials are created when battery packs
• NEVER force the battery pack into the