Filter
Top Products
English
4
Components
A. Trigger Switch B. Lock On Button
C. Spindle Lock D. Side Handle
E. Spindle F. Soft Mount
G. Rubber Bumper
Features
SWITCH
The tool is controlled by a trigger switch (A). A lock-on button (B)
provides increased comfort in extended use applications.
ROTATING REAR HANDLE (D28499 ONLY)
The rear handle can be positioned 30°, 60°, and 90° left and right
of center position.
ROTATING GEAR CASE (D28474, D28493, D28494, D28497)
For applications in which a tool will be dedicated for uses in edge
grinding and finishing work, the gear case may be rotated 90° left
or right of its original position. See page 8 for instructions on
rotating the gear case.
A
B
D
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety equip-
ment, such as those dust masks that are specially designed to filter
out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap
and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
• The label on your tool may include the following symbols. The
symbols and definitions are as follows:
V ............volts A ............amperes
Hz ..........hertz W............watts
min..........minutes ..........alternating current
........direct current
n
o ..........no load speed
............
Class II Construction
............earthing terminal
..........safety alert symbol .../min ....revolutions or
reciprocations
per minute
FAMILIARIZATION
Large Angle Grinders and Large Angle Sanders are designed for
heavy material removal in extended use applications. The following
grinders and sanders are described in this manual.
D28474 7" Angle Grinder 8,000 rpm
D28493 9" Angle Grinder 5,000 rpm
D28494 7"/9" Angle Grinder 6,000 rpm
D28497 7"/9" Angle Sander 6,000 rpm
D28499 7"/9" Angle Grinder 6,000 rpm
E
F
C
G
399080-02 rev 11/15/02 10:13 AM Page 4