Filter
Top Products
-35-
$1/;991:010//1??;>51?
@19-@ ;
Dust bag TS1004
Zero Clearance Insert TS1012
Dado Insert Set TS1013
@19-@ ;
Pusher Guide System TS1010
Table Saw Stand GTA500
'$&!
The gear case has been completely lubricated at the
factory. However, after six months to one year, de-
pending upon use, it’s wise to return your tool to the
nearest Service Center for the following:
GBrushes replaced.
GParts cleaned and inspected.
GRelubricated with fresh lubricant.
GElectrical system tested.
GAll repairs.
The following parts should be oiled occasionally with
SAE No. 20 or No. 30 oil, or WD 40 (Fig. 60).
1. Elevation, support rods, and gears.
2. Sliding rails and supports.
3. Table locking cams (Front & Rear).
Use only recommended accessories. Follow instructions that accompany accessories.
Use of improper accessories may cause hazards.
!
WARNING
All repairs, electrical or mechani-
cal, should be attempted only by
trained repairmen. Contact the nearest Factory
Service Center or Authorized Service Station or
other competent repair service. Use only identical
replacement parts, any other may create a hazard.
FIG. 59
!
WARNING
FIG. 60
1
2
3
BM 2610014415 01-11 E:BM 2610012089 12-10 E 1/10/11 7:17 AM Page 35