Bosch Power Tools PR20EVSK Router User Manual


 
PR008 BASE COVER
(Included with PR004 Offset Base. Also
available as optional accessory)
The optional PR008 Base Cover (Fig. 37) is
available to provide insulation from tool heat
in continuous and/or high-usage applications.
It can be used on the PR001 Fixed Base,
PR005 Tilt Base, and PR004 Offset Base
(with which it is standard equipment).
Installation of Base Cover
1. Remove clamp.
2. Slide cover over the top of the base and
into position
3. Reattach clamp. Make sure that washers
sit on outside of cover.
PR011 PLUNGE BASE
To install motor in plunge base:
1. Release the base clamp lever.
2. Line up the double triangle on the base with
double triangle on the motor. (Fig. 38)
•To position switch on the right side of the
base, line up the base’s arrow with arrow
on the motor housing that is below the
cord.
To position switch on the left, line up the
base’s arrow with arrow on the motor
housing that is below the switch.
3. Slide motor into base until resistance in felt.
(The base’s guide pin is now engaged into
slot on motor.)
4. Turn the motor clockwise until it stops.
5. Push the motor into the base as far as it will
go.
6. Fasten the base clamp lever.
DEPTH ADJUSTMENT
The plunge feature simplifies depth
adjustments and will allow the cutting bit to
easily and accurately enter the workpiece.
1. To lower, push plunge lock lever to the left,
apply downward pressure until you reach
desired depth, and release pressure on
lever to lock (Fig. 39). The plunge lock lever
is spring loaded and returns automatically to
the locked position.
2. To raise the router, push plunge lock lever to
the left, release pressure on router and the
router will automatically retract the bit from
the workpiece. It is advisable to retract the
bit whenever it is not engaged in work piece.
-22-
FIG. 37
BASE
COVER
REMOVE
CLAMP
BASE
CLAMP
LEVER
FIG. 38
FIG. 39
BM 2610021461 06-12_BM 2610021461 06-12.qxp 6/26/12 1:38 PM Page 22