Bosch Power Tools PR20EVSNK Router User Manual


 
-24-
EDGEFORMING DUST
EXTRACTION HOOD RA1175
Do not reach in area of the
bit while the router is ON or
plugged in. To avoid entangling hoses, do
not use this dust extraction hood at the
same time as any other dust extraction
hood.
This dust extraction hood (optional accessory)
is used for dust collection when edge-forming
(Fig. 42).
ATTACHING DUST EXTRACTION
HOOD
You can attach the edge-forming hood in
several places according to your needs or
preferences. The dust hood is attached to the
plunge base using two M4 thumb screws Two
auxiliary holes are provided in the plunge base
for attachment. Attach the dust extraction hood
— over the router’s sub-base — using the
screws provided with the hood. Securely
tighten the screws. (Figures 42 & 43).
DELUXE ROUTER GUIDE
(Not included, available as accessory)
The Bosch deluxe router guide is an optional
accessory that will guide the router parallel to a
straight edge or allow you to create circles and
arcs.
The deluxe router guide is supplied with two
rods and screws to fasten the guide (Fig. 44).
In addition, it features a fine adjustment knob
and indicator for accurately positioning the
edge guide relative to the bit. With the guide
installed and adjusted, the router should be fed
normally, keeping the guide in contact with the
edge of the workpiece at all times. The deluxe
router guide may also be positioned directly
under the router base for operations where a
cut is needed close to or at the edge of the work.
The deluxe router guide includes a dust
extraction hood and the VAC002 vacuum hose
adapter.
For complete instructions on installation and
operation, please refer to the instructions
which are included with this accessory.
!
WARNING
DUST EXTRACTION
HOOD
WORKPIECE
EDGE
ROUTER
SUBBASE
Dust Extraction Hood
(Optional Accessory)
M4 Thumb
Screws
FIG. 41
FIG. 42
M4 x 16mm
SCREW
SUBBASE
M4 x 16mm
SCREW
FIG. 43
PLUNGE BASE
DUST EXTRACTION
HOOD
BM 2610021461 06-12_BM 2610021461 06-12.qxp 6/26/12 1:38 PM Page 24