Filter
Top Products
13
After changing the miter angle, cut the wood facing at that selected
angle. If there is a gap between the blade, the wood facing and the work-
piece, move the wood facing slightly in the direction of the arrow and cut
it again.
CAUTION:
• Use straight wood of even thickness as the wood facing.
• Use screws to attach the wood facing to the guide fence. The screws
should be installed so that the screw heads are below the surface of the
wood facing.
• When the wood facing is attached, do not turn the turn base with the
handle lowered. The blade and/or the wood facing will be damaged.
NOTE:
• When the wood facing is attached, the maximum cutting capacities in
width will be reduced by thickness of the wood facing.
5. Cutting repetitive lengths
When cutting several pieces of stock to the same length, ranging from
300 mm to 400 mm, use of the set plate (optional accessory) will facili-
tate more efficient operation. Install the set plate on the holder (optional
accessory) as shown in the figure.
Align the cutting line on your workpiece with either the left or right side of
the groove in the kerf board, and while holding the workpiece from mov-
ing, move the set plate flush against the end of the workpiece. Then
secure the set plate with the screw. When the set plate is not used,
loosen the screw and turn the set plate out of the way.
NOTE:
• Use of the holder-rod assembly (optional accessory) allows cutting
repetitive lengths up to 2,200 mm approximately.
Carrying tool
Make sure that the tool is unplugged. Secure the turn base at right miter angle
fully by means of the grip. Lower the handle fully and lock it in the lowered
position by turning the handle latch to the locked position.
Carry the tool by holding both sides of the tool base as shown in the figure. If
you remove the holders, dust bag, etc., you can carry the tool more easily.
CAUTION:
• Always secure all moving portions before carrying the tool.
• Handle latch is for carrying and storage purposes only and not for any
cutting operations.
1. Blade
2. Wood facing
3. Wood facing
4. Workpiece
5. There should be no gap between
the blade, the wood facing and the
workpiece
1
3
4
5
2
003640
1. Set plate
2. Holder
3. Screw
1
2
3
001846
1. Handle latch
1
002147
002263