Filter
Top Products
SKU 93009
For technical questions, please call 1-800-444-3353
Page 7
Unpacking
When unpacking, check to make sure the following parts are included.
Concrete Wall Chaser with Two Blades and Spacers
Steel Chisel Point 8-1/2” Long
Two Point Spanner Wrench
Side Mount Auxiliary Handle
5mm Hex Key
When unpacking, check to make sure that all listed accessories are included, and that the product
is intact and undamaged.
WARNING! People with pacemakers should consult their physician(s) before using this product. Opera-
tion of electrical equipment in close proximity to a heart pacemaker could cause interference or
failure of the pacemaker.
Installing and Adjusting Blades and Spacers
1. Be sure the tool is turned OFF and is unplugged from its power source before installing or adjusting
blades.
NOTE: The blades can be spaced from .3” to 1” (8 to 26 mm) apart for various width grooves in the work
material, as desired.
2. Remove the Blade Guard Assembly (59) and
Height Adjuster (58) by removing Screws (63 and
64) and Depth Adjuster Handle (60). Put these
parts in a safe place to prevent their loss. Swing
the Height Adjuster (58) down clear of the blade
and remove it.
Blade Guard Assembly (59)
Tool shown with Blade Guard Assembly (59) removed.
Screws (63 and 64)
Depth Adjuster Handle (60) removed
Height Adjuster (58)