Filter
Top Products
3-15
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
OL-26701-02
Chapter 3 Installing Modules and Cables in the Chassis
Cable Management
Figure 3-9 Cable-Management Bracket Installation and Removal
Step 3
Insert and tighten the captive screw(s) to secure the bracket. (see Figure 3-9).
Step 4 Connect all the cables to the intended ports and pass them throught the cable management bracket in an
organized manner.
Removing a Cable-Management Bracket
To remove a cable-management bracket, follow these steps (see Figure 3-9):
Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 2 Note the current interface cable connections to the ports on the RP.
Step 3 Starting with the interface cable for the bottom port on the RP, disconnect the cable from the RP
interface.
Step 4 Repeat Step 3 for all remaining interface cables, proceeding from the bottom ports upward, then proceed
to Step 5.
Step 5 Loosen the captive installation screw on the cable-management bracket and remove the bracket from the
chassis (see Figure 3-9).
1 Cable-Management Bracket
1
332146