Clarke CFP-200 Sander User Manual


 
Page -26 -
Clarke
®
Operator's Manual- CFP Polisher
TROUBLESHOOTING
SWIRLS ON THE FLOOR AFTER SCRUBBING
Floor not clean.
Incorrect solution.
Area not properly swept - debris in pad or brush.
Improper pad or brush for the job.
Moving the machine too fast.
SWIRLS ON THE FLOOR AFTER DRY BUFFING
Moving the machine too fast.
Floor finish too soft.
Area not properly swept - debris in pad or brush.
Improper pad or brush for the job.
CIRCLES ON THE FLOOR
Machine standing still while the brush or pad is
running.
FLOOR FINISH REMOVED
Improper pad... too aggressive.
Solution too strong.
MACHINE WOBBLES DURING OPERATION
Defective pad... one side is more dense than the
other.
Machine left sitting on brush or pad for extended
period of time causing bristles or pad to “take a
set”.
Pad not “seated” properly into pad holder
bristles.
Warped block on brush or padholder - replace.
MACHINE DOES NOT RUN
Check plug for proper connection - on machine
and at wall outlet.
Check building circuit breaker.
Call for service.
LIGHT ON 2000DS MOTOR ILLUMINATES
Stop operating machine within 6 hours
Call for service
Replace carbon motor brushes.