Compatible Systems 2250R Router User Manual


 
24 Chapter 6 - Basic Configuration Guide
Set to allow dial-in and/or dial-out
CV: Use the Link Configuration: WAN 1.
TB: Use configure and set the Mode, ConnectMode, DialIn and/or
DialOut keywords in the Link Config WAN 1 section.
Suggested for Dial-On-Demand Operation
This mode of operation is only supported on the WAN 1 RS-232 inter-
face. Outgoing dial-on-demand requires some additional information.
Create dial-out script
Set dialing method
Set dial-out script to be used
Set inactivity time
CV: Use the Link Configuration: WAN 1 Dialog Box to set the dialing
method and to select a chat script (once you have created one).
Use the WAN Chat Scripts Dialog Box (under Global/WAN Chat
Scripts) to create your chat script.
TB: Use configure and then set the Dialing, DialOutScript,and
DropInact keywords in the Link Config WAN 1 section. Use
edit config and create a Chat section to contain your dialing
script.
IP Protocol
Required for IP
WAN interfaces which are set for PPP operation do not generally use an
IP address. They are set to act as an “unnumbered interface.” In this
mode of operation, there are no required settings.
Suggested for IP
These parameters help supply information about the segment that the
interface is connected to. With this information, routing can take place.
Set IP RIP 1 or IP RIP 2
Set IP static routes
CV: Use the TCP/IP Routing: WAN Dialog Box to set RIP, and the IP
Static Routing Dialog Box (under Global/IP Static Routes) to set
static routes.
TB: Use configure and set the RIPVersion keyword for in the IP
WAN 0 (and/or WAN 1) section. Use edit config and add static
routes in the IP Static section.