Filter
Top Products
adjustments
3. Place the head of a combination square in the
GROOVE. Adjust blade of square so that it just
touches the tip of the MARKED tooth.
4. Move squareto REAR, rotate bladetosee if MARKED
tooth again touches blade of square.
5. If tooth touches square at FRONT and REAR.
sawblade is PARALLEL to Miter Gauge Groove.
6. If tooth does not touch the same amount, the mecha-
nism underneath must be adjusted to make the blade
PARALLEL to GROOVE.
A. Rear Trunnion must be moved TOWARD to com-
binationsquare Ifthere isa space between marked
tOOthand end of square in step 4.
B. Rear Trunnion must be moved AWAY from the
square if marked tooth pushes square out of posi-
tion in the groove.
FRONT TRUNNION
REAR TRUNNION
....
7. Loosen all three screws that hold the Rear Trunnion
and all three screws that hold the Front Trunnion.
NOTE: Allsix screws can be reached through back
of saw. Use a 9/16 inchwrench. To reachleft-hancl
FrontTrunnion screw, tilt blade to 45°. After loosen-
ing screws, reposition blade at 90 a.
REAR-TRUNNION
SCREWS
RI|GHT-/HAND l CENTER LEFT-HAND
• (BEHIND HERE) (BEHIND HERE)
/ ! \,
FRONT-TRUNNION SCREWS
8. Usingawoodblock and mallet, as shown, move Rear
Trunnion to right or left as required to realign the
blade, if necessary, shift Front Trunnion in similar
manner; but do NOT move Front Trunnion unless
EDGE OF TRUNNION
CLAW HAMMER
WOOD BLOCK
PLACE BLOCK HERE
-- OR HERE
I
EDGE OF
REAR OFSAW CRADLE
40