Craftsman 113.298721, 113.298761 Saw User Manual


 
ad ustments
C. If blade is NOT SQUARE to table.., the 90• Stop
Screw must be ADJUSTED.
1. Unscrew 90° Stop Screw three to four turns
using 3/16 inch Hex "L" wrench.
2. Turn Tilt Handwheel clockwise one turn, then
turn Handwheel counterclockwiseuntilblade is
square with table.
3. Screw 90° Stop Screw IN until it stops. Check
once again for squareness and readjust screw,
if necessary.
i=
45" Position
TILT blade to LEFT as far as it will go.
1. Place an ACCURATE square against blade. Make
sure square isnot touchingthe TIP of one of the saw
TEETH.
If blade is 45° to table;
1. Check Pointer.
........ i
/
/
\
\
\
\
\
\
If blade isNOT 45' TO TABLE... STOP SCREW and
SCALE must be ADJUSTED.
1. Unscrew 45° Stop Screw three to four turns using
3/16 inch setscrew wrench.
2. Tum Tilt Handwheel until blade is 45 _to the table.
3. Screw 45° Stop Screw IN until it stops. Check once
again and readjust screw, if necessary.
!
/
© /
45 °
STOPSCREW
\
\
\
\
\
\
If POINTER DOES NOT point to the 45 ° mark on the
scale;
1. Remove Elevation Handwheel.
2. Loosen two screws on Scale and adjust Scale until
Pointer points to 45° mark.
3. Install Elevation Handwheel.
TILT MECHANISM
the nut inside using a 3/8 inch wrench.
42