Filter
Top Products
M
unpacking and checking contents
TOOLS NEEDED
Phillips Screwdriver
Combination Square
Wrenches
7116 in. 112 In. 9/16 In.
Medium Screwdriver
Small Screwdriver
SIZE
Sot Screw Wrenches
3/32 In.
118 in.
5/32 in.
COMBINATION SQUARE MUST BE TRUE.
DRAW LIGHT LINE ON
BOARD ALONG THIS EDGE, *_-,
I
STRAIGHT EDGE OF BOARD
3/4" THICK. THIS EDGE MUST
BE PERFECTLY STRAIGHT.
SHOULD BE NO GAP OR OVERLAP
HERE WHEN SQUARE IS FLIPPED
OVER IN DOTTED POSITION,
Separate all parts from packing materials and check
each one with the illustratbn and the listof Loose Parts
to make certain all items are accounted for, before
discarding any packing material.
WARNING: If any parts are missing, do not attempt
to assemblethe table saw, plug in the power cord or
turn the switch or=until the missing parts are ob-
tained and are Installed correctly.
Remove the protective oilthat isapplied to the table top
andedgesof thetable. Use anyordinary householdtype
grease and spot remover.
WARNING: Toavoidfireor health hazard, never use
gasoline, naptha, or similar highly volatile solvents.
Apply a coat of automobile wax to the table.
Wipe all parts thoroughly with a clean, dry cloth.
WARNING: Foryour own safety, neverconnect plug
to power source outlet until a, assembly steps are
complete, and you have read and understand the
safety and operational Instructions.
ffEM PART NAME QTY.
A Blade Guard and Spreader ........................... 1
B Rip Fence ...................................................... 1
C Owner's Manual ............................................ 1
D Cast Iron Table Extensions ........................... 2
E Miter Gauge .................................................. 1
H Rip Fence Guide Bar with Rip Scale (Front). 1
M Support, Motor Base ..................................... 1
Q Rip Fence Guide Bar (Rear) ......................... 1
R Side Stiffener ................................................. 2
S Leg ................................................................ 4
T End Stiffener ................................................. 2
U Motor ............................................................. 1
Bag of Loose Parts
(Containing the following items)
G Outlet, On/Off with Key ................................. 1
J Handwheel .................................................... 2
AM Bracket, "L" Mounting (Model 113298721)... 1
Bag of Loose Parts ........................................ 3
Bag of Loose Parts
(Containing the following items)
F Wrench .......................................................... 1
K Belt, "V" 1/2 x 41 ........................................... 1
L Pulley, 1/2 dia. with 5/8 Bore ......................... 1
N Spreader, Rod ............................................... 1
0 Blade Guard Support .................................... 1
P Spreader Support .......................................... 1
S
u
(MODEL 113.298761)
(MODEL 113.298721)