Filter
Top Products
ATTACHING THE FENCE TO
THE TABLE (Fig. 6)
,_ WARNING" Always
unplug the router before at-
taching or removing the fence°
The fence has been shipped
completely assembled.
1. Place the fence assembly
on the table with the four
wing nuts facing toward you.
=
Align the two holes on the
bottom of fence assembly
with the two channels on
the router table.
3_ Secure the fence to the
table with two clamping
knobs (5), two plain washers
(11), and two short, round-
head, square-neck bolts (6).
TO ATTACH THE MITER
GAUGE (Fig. 7)
The miter gauge has been
shipped completely assembled.
Attach the miter gauge to the
table by placing the miter-gauge
bar in the slot on the table.
MOUNTING THE TABLE TO
A WORK SURFACE (See Fig. 8)
1. Place the router table, up-
right, on a sturdy surface,
e.g., work stand, work-
bench, or counter top.
.
While holding the router
table in place, mark on the
work surface the location
of the two mounting holes
(11/32-in diao) in each of
the legs.
3. Remove the router table.
Fig. 6
Fig. 7
Fig. 8
28180 ManuaLRevlsed_07_9228 Page16