DIN Rail Universal Dimmer Crestron DIN-1DIMU4
NET ID display to change the least significant digit of the Net ID
number.
• When the desired Net ID is displayed, press the SETUP button to
exit the Setup mode. The SETUP LED extinguishes.
NOTE: If an invalid Net ID is set (00, 02, FF), “Er” will be
displayed on the NET ID display. The DIN-1DIMU4 will revert to
the previously set Net ID.
NOTE: The DIN-1DIMU4 will leave the Setup mode after 10
seconds of inactivity. The DIN-1DIMU4 will revert to the
previously set Net ID.
NOTE: A small label (with numbers and letters) is provided on
the front panel of the DIN-1DIMU4 to document the unit’s Net ID
in the case where power is not available. Apply a mark over the
digits that correspond to the assigned Net ID.
NET ID Label (“3C” Shown)
When setting the Net ID, consider the following:
• The Net ID of each unit must match an ID code specified in the
SIMPL™ Windows
®
program.
• Each network device must have a unique Net ID.
For more details, refer to the Crestron Toolbox help file.
Installation
The DIN-1DIMU4 must be installed by a licensed electrician, in
accordance with all national and local codes.
CAUTION: This equipment is for indoor use only. Mount in a well
ventilated area. The ambient temperature must be 0º to 40º C
(32º to 104º F). The relative humidity must be 10% – 90%
(non-condensing).
14 • DIN Rail Universal Dimmer: DIN-1DIMU4 Operations & Installation Guide – DOC. 6668A