Filter
Top Products
INSTALLATION INSTRUCTIONS
LAT-NR320
LED Tail Lights for 1970 Chevelle
MAN#650202
Kit Includes:
Installation:
1. Remove the tail light lenses. There are four screws holding each lens in.
2. Remove the tail light bulbs.
3. We recommended that the lens and housings be cleaned to insure proper mounting and
visibility of the LED assembly. If the lenses are in bad shape a new set is suggested.
4. DO NOT remove the tape from the led assemblies yet!
5. Test fit the assembly into the lens as shown below to make sure it aligns correctly.
6. Make sure you have BOTH lenses clean and dry so the single use primer applicator can be
used for both lenses. Apply the primer to the top and bottom edges of the lens where the tape
will attach. AFTER THE PRIMER HAS BEEN APPLIED, LET THE LENS DRY FOR 5
MINUTES BEFORE GOING ON.
MAN#650202