Delta 17-990X Drill User Manual


 
9
ASSEMBLY
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE
1. Attach the column (A) Fig. 3 to the base (B) using
the four M10x40mm hex head screws (C), three of
which are shown. Loosely thread the locking lever
(D) into the table mounting bracket (E). Loosen the
set screw (D) with the supplied 3mm wrench and
remove the ring (E) and raising rack (F).
2. Insert the small end of the worm gear (G) Fig. 4 and
Fig. 5, through the hole (H) from the inside of the
table bracket. Make certain that the worm gear
engages the internal gear in the table bracket.
3. Insert the raising rack (F) Fig. 6 (removed in STEP 1)
into the groove in the table bracket (I). Make certain
that the teeth of the internal gear, located inside the
table bracket, are engaged with the teeth of the
raising rack (F).
4. Slide the raising rack (F) Fig. 7 and table bracket (J) on the drill press column. Make certain that the bottom of the
raising rack (F) Fig. 8 is engaged with the flange (K) on the drill press base.
A
B
C
D
E
Fig. 3
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
3mm Hex Wrench (Supplied) 5mm Hex Wrench (Supplied) Adjustable Wrench
The assembly time for this unit is approximately 1-2 hours.
b ac e a e ce a a e o gea e gages e
internal gear in the table bracket.
F
Fig. 4
Fig. 5
G
H
H
G
F
I
Fig. 6
F
I
F
J
Fig. 7