Filter
Top Products
14
105635
Operation
1. Grasp barrel assembly and slide forward rapidly until it stops. Push barrel
assembly back into tool to the closed position. This sets piston into firing
position.
4. Place the muzzle of tool perpendicular to work surface without tilting the tool.
Push tool against work surface until sliding action of barrel stops.
3. Select the proper power level of power load strips. Always insert power load
strips through bottom of handle. Push power load strip in until even with bottom
of handle.
NOTE:
Failure to start with
the lowest power
level can result in
overdrive condition
and will result in
damage to tool
(See page 13).
482-70
482-71
2. Insert power fastener into muzzle of tool, head end first. Push the fastener until
point is even with end of tool.