Filter
Top Products
7
105635
TILE
BRICK
482-33
CAST IRON GLASS
G 018
G 018
G 018
G 018G 018
Safety Precautions
3. Never make fastenings in spalled or cracked areas.
2. Never attempt to drive power fasteners into very hard or brittle materials
including, but not limited to cast iron, glass, tile, stone, brick, or hardened steel.
Materials of this type tend to shatter and create hazard from flying particles.
4. Never drive power fasteners into thin or easily penetrated materials unless it is
backed by concrete or steel. When in doubt, such as when base material is
concealed, conduct a Center Punch Test (See page 6). Check continually to
avoid fastening into unsuitable material, especially in older buildings.
5. Do not fasten through or within 1/2" of predrilled or pre-punched holes.