DeVillbiss Air Power Company D26368 Air Compressor User Manual


 
10- ENG
D26368
Rubber Feet
Screw
Nut
Wheel
Shoulder Bolt
Assembly for “Vertical” units
Tools Required for Assembly
1 - 9/16” socket or open end wrench
1 - 1/2” socket or open end wrench
1. Remove all packaging leaving the air
compressor on the pallet.
2. Remove and discard the (4) screws
holding the air compressor to the
pallet.
It may be necessary to
brace or support one
side of the air compressor when
removing the pallet because the air compressor will have a tendency to
tip.
3. Carefully remove the air compressor from the pallet.
It will be necessary to brace or support one side of the
outfit when installing the wheels because the compressor
will have a tendency to tip.
4. Attach wheels with shoulder bolts and nuts as shown.
5. Tighten securely. NOTE: The unit will sit level if the wheels are properly
installed.
The wheels and handle do not provide adequate
clearance, stability or support for pulling the unit up and
down stairs or steps. The unit must be lifted, or pushed up a ramp.
6. Attach rubber feet with the screws provided as shown in previous figure.
7. Tighten snug or until rubber foot begins to compress.
Screws