Filter
Top Products
11
FENCE
1. Align the two holes (A) Fig. 9 in the front fence rail with the two holes (B) in the front of the table.
NOTE: Make sure that the scale on the front fence rail is facing upward.
2. Insert a 1/4-20 x 1-1/2" socket-head cap screw through one of the holes (A) Fig. 9 hole in the front fence rail. Place
a spacer on the screw between the front fence rail and the table. Thread the screw into the front of the table. Repeat
for the other hole (A) in the front fence rail. Tighten the two screws securely using the 5mm hex wrench.
3. Align the two holes (C) Fig. 9A in the rear fence rail with the two holes (D) in the rear of the table.
4. Insert a 1/4-20 x 1" socket head cap screw through one of the holes (C) in the rear fence rail. Thread the screw into
the matching hole in the rear of the table. Repeat for the other hole in the rear fence guide and the table. Tighten
the two screws securely using the 5mm hex wrench.
5. Loosen the fence lock knob (E) Fig. 10 and position the opening of the fence bracket over the front guide rail. Slide
the fence on the fence guide rail (Fig. 11).
NOTE: The fence can be attached to either side of the blade.
6. Tighten fence lock knob (E) Fig. 11.
Fig. 9
Fig. 9A
A
B
C
D
Fig. 10
Fig. 11
E
E
TABLE INSERT
Place the table insert (A) Fig. 12 in the table cutout. NOTE: A tab (B) is provided on the insert that engages with the
notch (C) in the table opening.
Fig. 12
A
B
C
Fig. 13
FENCE EXTENSION
Loosen the two knobs (A) Fig. 13 to extend the table.
A
A