Filter
Top Products
English
14
Troubleshooting Guide
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
TROUBLE! SAW WILL NOT START
WHAT’S WRONG? WHAT TO DO…
1. Saw not plugged in 1. Plug in saw.
2. Fuse blown or circuit breaker tripped 2. Replace fuse or reset circuit breaker
3. Cord damaged 3. Have cord replaced by authorized service center
4. Brushes worn out 4. Have brushes replaced by authorized service
center or replace them yourself as instructed on
page 7.
TROUBLE! SAW MAKES UNSATISFACTORY CUTS
WHAT’S WRONG? WHAT TO DO…
1. Dull blade 1. Replace blade. See page 4 .
2. Blade mounted backwards 2. Turn blade around. See page 4.
3. Gum or pitch on blade 3. Remove blade and clean with turpentine and
coarse steel wool or household oven cleaner.
4. Incorrect blade for work being done 4. Change the blade type. See page 3.
TROUBLE! BLADE DOES NOT COME UP TO SPEED
WHAT’S WRONG? WHAT TO DO…
1. Extension cord too light or too long 1. Replace with adequate size cord. See page 1.
2. Low house current 2. Contact your electric company
TROUBLE! MACHINE VIBRATES EXCESSIVELY
WHAT’S WRONG? WHAT TO DO…
1. Saw not mounted securely to stand or work bench 1. Tighten all mounting hardware. See page 4.
2. Stand or bench on uneven floor 2. Reposition on flat level surface. See page 4.
3. Damaged saw blade 3. Replace blade. See page 4 .
TROUBLE! DOES NOT MAKE ACCURATE MITER CUTS
WHAT’S WRONG? WHAT TO DO…
1. Miter scale not adjusted correctly 1. Check and adjust. See page 5.
2. Blade is not square to fence 2. Check and adjust. See page 6.
3. Blade is not perpendicular to table 3. Check and adjust fence. See page 6.
4. Workpiece moving 4. Clamp workpiece to fence or glue 120 grit
sandpaper to fence with rubber cement.
TROUBLE! MATERIAL PINCHES BLADE
WHAT’S WRONG? WHAT TO DO…
1. Cutting bowed material 1. Position bowed material as shown on page 12.