Filter
Top Products
English
3
Specifications
CAPACITY OF CUT
48 degree miter left and right
48 degree bevel left: 3 degree right
0 degree miter
Max. Height 3.9" Result Width 5.9"
Max. Width 7.9" Result Height 2.5"
45 degree miter
Max. Height 3.9" Result Width 4.1"
Max. Width 5.5" Result Height 2.5"
45 degree bevel
Max. Height 2.7" Result Width 5.9"
Max. Width 7.9" Result Height 1.7"
DRIVE
120 Volt Motor
2000 Watts 15 Amp Motor
4000 RPM Cut Helical Gears
Automatic Electric Brake with Roller Bearings
Carbide Blade
Optional Accessories
The following accessories, designed for your saw, may
be helpful. In some cases, other locally obtained work
supports, length stops, clamps, etc., may be more
appropriate. Use care in selecting and using acces-
sories.
Extension, Work Support: DW7050
Used to support long overhanging workpieces, the
work support is user assembled and stores conve-
niently under the saw table. Your saw table is
designed to accept two work supports; one on each
side (page 4).
Adjustable Length Stop: DW7051
Requires the use of one work support (see above).
It is used to make repetitive cuts of the same length
from 0 to 42" (page 4).
Clamp: DW7052
Used for firmly clamping workpiece to the saw
fence for precision cutting (page 4).
Dust Bag: DW7053
Equipped with a zipper for easy emptying, the dust
bag will capture the majority of the sawdust pro-
duced. (Not shown))
Crown Molding Fence: DW7054
Used for precision cutting of crown molding
(page 4).
SAW BLADES: ALWAYS USE 12" SAW BLADES WITH
1" ARBOR HOLES. SPEED RATING MUST BE AT LEAST
4800 RPM.
FIG. 2
GUARD
RIGHT
SIDE
FENCE
MITER
CLAMP
KNOB
MITER
LATCH
MITER
SCALE
BENCH
MOUNTING
HOLES
LEFT SIDE
CLAMPING
KNOB
LOCK
DOWN
PIN
REAR
LOWER
GUARD
OPERATING
HANDLE
BLADE
WRENCH
FIG. 3
TRIGGER
SWITCH
CARRYING
HANDLE
SPINDLE
LOCK
BUTTON
LEFT
SIDE
FENCE
MITER
CLAMP
KNOB
MOTOR
HOUSING
REAR
LOWER
GUARD
BEVEL
STOP
BEVEL
SCALE
MITER
LATCH
MITER
SCALE
HAND
INDENTATION
BEVEL CLAMP
KNOB
DUST
SPOUT
BRUSH
INSPECTION
CAP
CAT APPLICATION BLADE NO. OF TYPE
NO. DESC. TEETH OF CUT
DW3128 Fine Trim Thin Kerf 80 Smooth,
Molding Splinter Free
DW3228 Fine Trim Thick Kerf 80 Very Smooth,
Molding Splinter Free
DW7296 Fine Trim Thick Kerf 96 Ultra Smooth
Molding Splinter Free
DW3123 Framing, Thin Kerf 32 Fast Cut
Decking
DW3224 Framing, Thick Kerf 48 All around cutting
Decking
DW3226 Trim, Framing Thick Kerf 60 Smooth Cross Cuts
Decking
DW3229 Non-Ferrous Thick Kerf 80 Straight, burr free
Metals special tooth
grind