DigiPower PD-UAC502 Battery Charger User Manual


 
| 1 | 2 | 3 | 4 | 5 | 6
Adjusting the switch after your
device is plugged in has no effect on
performance.
For best charging results for your
device follow these guidelines:
1. iPad - iPod, iPhone and iPad
(Cable not included)
TABLE OF CONTENTS English
Technical Specifications.............1
Use of the wall charger..............1
Troubleshooting for the wall charger...3
Limited Warranty ..................5
Warning ..........................6
CONTENIDO Español
Especificaciones técnicas ............7
Para usar el cargador de pared ........7
Resolución de problemas
para el cargador de pared ............9
Garantía Limitada ...................11
¡Ad vertencia ......................12
TABLE DES MATIÉRES Français
Caractéristiques techniques..........13
Utilisation du chargeur mural ........13
Dépannage - chargeur mural.........15
Garantie Limitée . . . . . . . . . . . . . . . . . . . 17
Mise en garde! ....................18
Declaration of Conformity with
FCC Rules for Electromagnetic
Compatibility
We, Mizco International, Inc., of 80
Essex Ave East, Avenel, NJ 07001,
declare under our sole responsibility
that the product PD-UAC502 to which
this declaration relates, complies with
Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one of the following
measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Mizco International, Inc., is not
responsible for any interference caused
by unauthorized modifications to this
equipment. Such modifications could
void the user’s authority to operate this
equipment.
ICES
This Class B digital apparatus complies
with Canadian ICES-003.
English
USER GUIDE
GUÍA DEL USUARIO
GUIDE D’UTILISATION
Item No. PD-UAC502
Universal Tablet and
Smartphone Wall Charger
Cargador de pared universal
para tableta y teléfono
inteligente
Chargeur mural universel
pour tablettes et téléphones
intelligents
If the charger does not charge your device
or it appears to be charging more slowly
than normal unplug the cable from your
device, try another switch position on the
charger then plug the cable back into your
device.
Check that your device does not require
more than 2.1 amps to charge, this
information should be listed on the bottom
of the charger that came with your device.
Note: This charger will not work with the
HP TouchPad Tablet..
LIMITED WARRANTY
Mizco’s responsibility with regard to this
limited warranty shall be limited solely
to the repair or replacement at its option,
of any product, which fails during normal
consumer use for a period of 1 Year from
the date of purchase. This warranty does
not extend to damage or failure, which
results from misuse, neglect, accident,
alteration, abuse, improper installation
or maintenance. If at any time during the
1 Year period following the purchase the
product fails due to defects in materials or
workmanship, return the defective product
with freight prepaid and proof of purchase.
WARNING! IMPORTANT SAFETY
INSTRUCTION !
Failure to read and follow these safety
instructions could result in fire, explosion,
electrical shock or other hazard, causing
serious and/or fatal injury and/or property
damage.
Do not modify, disassemble, open, drop,
crush, puncture or shred the product.
Do not expose the product to rain or water.
Keep away from open flame or sunlight to
prevent heat build-up.
This product is not a toy.
Keep away from children.
Insure that all persons who use the product
read and follow these warnings and
instructions.
TECHNICAL SPECIFICATIONS FOR
THE WALL CHARGER
AC Voltage input range: 100-240V
Operating frequency: 50Hz ~ 60Hz
Output voltage: 5V
Output current: 2.1A
Over voltage protection
Short circuit protection
USE OF THE WALL CHARGER
The wall charger features a 3 position
switch to allow for optimal charging of
a wide range of USB powered devices.
For optimal charging the switch
must be in its proper position before
attaching the cable to your device.
3
1
2
©2012 Mizco International, Inc. Avenel, New Jersey
All rights reserved. Todos los derechos
reservados.Tous droits réservés.www.
digipowersolutions.com tel: 800•838•3200
email: digipowersolutions@mizco.com
DIGIPOWER is a registered trademark of Mizco
International Inc.
DIGIPOWER es una marca registrada de Mizco
International Inc.
DIGIPOWER est une marque de commerce
enregistrée de Mizco International, Inc.
All brands represented herein are registered
trademarks of their respective manufacturers.
Todas las marcas representadas aquí son
marcas comerciales
registradas de sus fabricantes respectivos.
Toutes les marques représentées ici sont des
marques déposées de
leurs fabricants respectifs.
2. Samsung – Samsung Galaxy Tab (Use
included Samsung cable)
3. BlackBerry - BlackBerry PlayBook
and smartphones, Android tablets and
smartphones, Windows smartphones,
ebook readers, all other USB devices.
(Use included micro USB cable).
TROUBLESHOOTING FOR THE WALL
CHARGER
If the charger appears to stop working,
unplug it for 10 seconds and plug it back
in. If the charger still does not work, try to
charge a different compatible device. If the
charger still does not work, contact tech
support.