Filter
Top Products
DSL-G624T Wireless A DSL Router User’s Guide
Hardware Installation
The DSL-G624T maintains three separate interfaces, an Ethernet LAN, a wireless LAN and an ADSL (WAN) interface.
Place the Router in a location where it can be connected to the various devices as well as to a power source. The Router
should not be located where it will be exposed to moisture or excessive heat. Make sure the cables and power cord are
placed safely out of the way so they do not create a tripping hazard. As with any electrical appliance, observe common
sense safety procedures.
The Router can be placed on a shelf or desktop, ideally you should be able to see the LED indicators on the front if you
need to view them for troubleshooting.
Choosing the Best Location for Wireless Operation
Many environmental factors can affect the effective wireless function of the DSL-G624T. If this is your first time
setting up a wireless network device, read and consider the points listed below.
The access point can be placed on a shelf or desktop, ideally you should be able to see the LED indicators on the front if
you need to view them for troubleshooting.
Designed to go up to 100 meters indoors and up to 300 meters outdoors, Wireless LAN lets you access your network
from anywhere you want. However, the number of walls, ceilings, or other objects that the wireless signals must pass
through can limit signal range. Typical ranges vary depending on the types of materials and background RF noise in
your home or business. For optimum range and signal strength, use these basic guidelines:
1. Minimize the number of walls and ceilings between access points and clients:
The signal emitted from Wireless LAN devices can penetrate through ceilings and walls. However, each wall
or ceiling can reduce the range of Wireless LAN devices from 1 to 30M. Position your wireless devices so that
the number of walls or ceilings obstructing the signal path is minimized.
2. Consider the direct line between access points and workstations: A wall that is 0.5 meters thick, at a 45-
degree angle appears to be almost 1 meter thick. At a 2-degree angle, it is over 14 meters thick. Be careful to
position access points and client adapters so the signal can travel straight through (90º angle) a wall or ceiling
for better reception.
3. Building Materials make a difference: Buildings constructed using metal framing or doors can reduce
effective range of the device. If possible, position wireless devices so that their signal can pass through drywall
or open doorways, avoid positioning them so that their signal must pass through metallic materials. Poured
concrete walls are reinforced with steel while cinderblock walls generally have little or no structural steel.
4. Position the antennas for best reception. Play around with the antenna position to see if signal strength
improves. Some adapters or access points allow the user to judge the strength of the signal.
5. Keep your product away (at least 1-2 meters) from electrical devices:
Position wireless devices away from electrical devices that generate RF noise such as microwave ovens,
monitors, electric motors, etc.
8