D-Link DSL-G684T Router User Manual

DSL-G684T Wireless ADSL Router User Guide
RIP-1/RIP-2 – The DSL-G684T supports both RIP-1 and RIP-2 exchanges with other routers. Using both versions
lets the Router to communicate with all RIP enabled devices.
Static Routing – This allows you to select a data path to a particular network destination that will remain in the
routing table and never “age out”. If you wish to define a specific route that will always be used for data traffic
from your LAN to a specific destination within your LAN (for example to another router or a server) or outside
your network (to an ISP defined default gateway for instance).
Default Routing – This allows you to choose a default path for incoming data packets for which the destination
address is unknown. This is particularly useful when/if the Router functions as the sole connection to the Internet.
ATM (Asynchronous Transfer Mode) – The DSL-G684T supports Bridged Ethernet over ATM (RFC1483), IP
over ATM (RFC1577) and PPP over ATM (RFC 2364).
Precise ATM Traffic Shaping – Traffic shaping is a method of controlling the flow rate of ATM data cells. This
function helps to establish the Quality of Service for ATM data transfer.
High Performance –Very high rates of data transfer are possible with the Router. Up to 24Mbps downstream bit
rate using the G.dmt standard.(For ADSL2+).
Full Network Management – The DSL-G684T incorporates SNMP (Simple Network Management Protocol)
support for web-based management and text-based network management via an RS-232 or Telnet connection.
Telnet Connection – The Telnet enables a network manager to access the Router’s management software remotely.
Easy Installation The DSL-G684T uses a web-based graphical user interface program for convenient
management access and easy set up. Any common web browser software can be used to manage the Router.