Filter
Top Products
Dukane Manual Part No. 403-570-01
Page 45
Section 5 - Touch Screen Menus
The Home Offset (Deg.) eld is used to specify an angular
offset of the homing spin orientation. The tooling hub
home orientation is set at the factory such that the slot
in the hub shown in Figure 3-2a is closest to the front
of the machine. This position is the 0 degree reference
for the spin motor and all spin orientations are dened
relative to it. Unless a specic situation requires a non-
zero offset, it is most convenient to retain the factory
default value.
The Set Password button is used to set the password,
which must subsequently be entered to change
programmed machine settings. The default password is
0 (zero) so that password–protected screens are easily
accessed by just pressing the Enter key on the Enter
Password Code screen. The password is a numerical
value with a maximum 10–digit value of 4 294 967
295. The password–protected screens and menus are
shown in Figure 5–35.
The buttons English, French, Czech, and German set
the active language on the welder. When one of these
buttons is pressed, the menu language changes to the
selected language and remains in effect while the welder
is powered up. To preserve the language selection
between power cycles, press the Save Language
Select button.
The Software Info button displys a screen with software
revisions of the welder components as shown in Figure
5-36.
Figure 5–35 Password-Protected Screens and
Menus
RUN
SETUP
TOOLS
SELECT
SETUP
SYSTEM
SETUP
UTILITIES
Set Password
WELD
POST-
WELD
PRE-
WELD
Figure 5–36 Welder Software Information