Filter
Top Products
Dukane Manual Part No. 403-570-01
Page 91
Section 12 - Specications
Tooling Specications
Tooling Size
Refer to Table 5-I for maximum tooling sizes.
Machine Weight
The Dual Servo Spin Welder weighs approximately 400
lbs. (182 kg). It should be mounted on a table or bench
capable of supporting 650 lbs. (295 kg) to accommodate
the additional force imposed by the vertical movement of
the motor and slide during the spin welding operation.
Use mechanical means such as a forklift or hoist to place
the servo spin welder on its work bench. There are two
3
/4 inch lifting eyes located at the top of the column (see
Figure 3–7) for a lifting ring or strap.
Power Requirements
The Dual Servo Spin Welder requires a 240 VAC 1–
phase outlet rated at 20 Amps. All welder models use
the same power cord and plug. The AC power cord
has a 240 VAC, single phase plug which is designed
for a NEMA 6–20R conguration wall receptacle shown
in Figure 12–1.
Operating
Environment
Operate the Dual Servo Spin Welder within these guidelines:
Temperature: 40°F to 95°F (+5°C to +35°C)
Altitude: 4570 m (15,000 ft)
Air Particulates: Keep the welder dry.
Minimize exposure to moisture, dust
dirt, smoke and mold.
Humidity:
5% to 95% non–condensing @ +5°C to
+30°C
220 Volt AC Socket
(NEMA 6–20R)
240 Volt AC Socket
(NEMA 6–20R)
Figure 12–1 240V AC Single–Phase AC Receptacle