Epson DW621 Router User Manual


 
4
FINE ADJUSTMENT (FIG. 6)
Use the fine adjuster when not using a depth template, or if the depth
of cut needs readjustment.
1) Adjust the depth of cut as described above.
2) Set the fine adjuster to zero using the inner ring. Hold the top
portion while setting the lower ring to zero.
3) Rotate the fine adjuster to the required position. Graduations are
on the top of the fine adjustment knob.
Lock-On/Lock-Off Switch (Fig. 7)
The lock-on/lock-off switch is located in the handle on the right side.
The router is normally locked-off.
To start the router, press the thumb lock and squeeze the trigger. To
lock the switch on, squeeze the trigger, press the thumb lock forward
and release the trigger. To turn the router off, release the switch. If the
tool is locked-on, press the trigger again and release the switch.
NOTE: Loosen the plunge limiter and allow the router carriage to
return to its rest position before switching off.
English
0.
0.6
FIG. 6
FIG. 7
2) Unlock the plunge lock handle.
3) Lower the router carriage until the cutter is in contact with the
workpiece
4) Tighten the plunge lock handle by turning it clockwise.
5) Turn the height adjustment knob counterclockwise until it hits the
revolver depth stop (Fig. 5).
6) Set the quick adjuster to zero, by turning the inner ring knob
clockwise.
7) Adjust the depth of cut by rotating the height adjust knob clockwise
to the desired depth of cut. The adjustment range is indicated by
the arrow.
8) Tighten the plunge limiter by turning the depth stop bolt clockwise.
TRIPLE DEPTH ADJUSTMENT USING THE REVOLVER DEPTH
STOP (FIG. 5)
The revolver depth stop can be used to set three different depths. This
is useful for deep cuts, performed in steps.
1) Place a depth template between the depth stop and the revolver
depth stop to adjust the exact cutting depth.
2) If required, set all three screws.
5/8
1/2
3/4
REVOLVER DEPTH
STOP
FINE
ADJUSTMENT
KNOB
FIG. 5
TRIGGER
PRESS TO LOCK ON
THUMB LOCK