Filter
Top Products
4 - 122 COMMAND REFERENCE
TRIGger[:SEQuence[1]]:SLOPe
TRIGger[:STARt]:SLOPe
Syntax:
TRIGger[:SEQuence[1]]:SLOPe POSitive | NEGative | EITHer
Alias:
TRIGger[:STARt]:SLOPe POSitive | NEGative | EITHer
POSitive Positive trigger edge.
NEGative Negative trigger edge.
EITHer Triggering is done at a positive and at a negative
edge.
Query form:
TRIGger[:SEQuence[1]]:SLOPe?
TRIGger[:STARt]:SLOPe?
Response:
POS | NEG | EITH
POS Positive trigger edge.
NEG Negative trigger edge.
EITH Trigger edge is both positive and negative.
Description:
Controls the trigger edge (slope) to be detected. The command sets the trigger
slope and the query returns the trigger slope. The dual slope mode (EITHer) is
only possible, if the following selections are valid:
- the digital mode INSTrument DIGital
- the real-time mode SENSe:SWEep:REALtime ON
- the ’single-shot’ mode INITiate:CONTinuous OFF
- the trigger source is INTernal TRIGger:SOURce INTernal1|2|3|4
After a
*
RST command, the trigger slope is POSitive.