Filter
Top Products
5
• Do not use the power tool if the switch does not turn it
on and off. Any power tool that cannot be controlled with the
switch is dangerous and must be repaired.
• Disconnect the plug from the power source before
making any adjustments, changing accessories, or
storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
• Store idle power tools out of the reach of children and
do not allow persons unfamiliar with the power tool or
these instructions to operate the power tool. Power tools
are dangerous in the hands of untrained users.
• Maintain power tools. Check for misalignment or binding of
moving parts, breakage of parts and any other condition that
may affect the power tool’s operation. If damaged, have the
power tool repaired before use. Many accidents are caused
by poorly maintained power tools.
• Keep cutting tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are less likely to bind
and are easier to control.
• Use the power tool, accessories and tool bits etc.,
in accordance with these instructions and in the manner
intended for the particular type of power tool, taking
into account the working conditions and the work to be
performed. Use of the power tool for operations different
from intended could result in a hazardous situation.
Service
• Have your power tool serviced by a qualified repair
personnel using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
Additional safety rules for electric routers
• Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
• Fully unwind cable drum extensions to avoid potential
overheating.
• When an extension cable is required, you must ensure it has
the right ampere rating for your power tool and is in a safe
electrical condition.
• Ensure your mains supply voltage is the same as your tool
rating plate voltage.
• Your tool is double insulated for additional protection against a
possible electrical insulation failure within the tool.
• Always check walls, floors and ceilings to avoid hidden power
cables and pipes.
• After long working periods external metal parts and
accessories could be hot.
• Always wear eye and ear protection and use a dust mask.
• Handle router bits with care, they can be extremely sharp.
• Check the bit carefully for signs of damage or cracks before
use. Replace cracked or damaged bits immediately.
• Remove all nails, screws and other objects from the
workpiece. You can damage the bit and the tool by cutting
into a nail or other metal. It can also present a safety hazard.
• Always use both handles and make sure that you have a
good grip on the router before proceeding with any work.
• Keep your hands away from the rotating bit.
• Make sure that the bit is not in contact with the workpiece
when you switch the machine on.
• Before using the tool to make a cut, switch on and let it run
for a while. Watch for vibration or wobbling that could indicate
an improperly installed bit.
• Take notice of the direction of rotation of the bit and the
direction of feed.
• Do not leave the machine running unattended. Operate the
tool only when controlled by both hands.
• Always switch off and wait until the bit has come to a
complete standstill before removing the machine from the
workpiece.
• Do not touch the bit immediately after operation. It may be
extremely hot and could burn your skin.
• Rags, cloths, cord, string and the like should never be left
around the work area.
• Use safety equipment including safety goggles or shield, ear
protection, dust mask and protective clothing including safety
gloves.