Filter
Top Products
308-3419
Setup
and Shutdown
WARNING
EQUIPMENT
MISUSE HAZARD
This gun is for use with water-based contact adhe-
sives only. Any other use of the gun could cause
unsafe
operating conditions or damage to the gun.
1. Connect the air line.
A. Connect
the air hose (C) to the gun air inlet
(B). See Fig. 6.
C
B
02751
Fig. 6
1
1
1/4
npsm
B. Connect
the other end of the air hose (C) to a
regulated air supply line (G).
See Fig. 7.
NOTE:
Fig. 7 shows the air supply line filter (F), air
regulator (E), and air shut-of
f valve (D).
01990
C
EF
Fig. 7
G
D
2. Flush the adhesive and activator fluid
lines with water and blow them out
with air before connecting them to the
gun.
3. Connect the adhesive fluid hose.
A. Connect
the fluid hose (R) to the gun adhesive
inlet (S). See Fig. 8.
S
02752
Fig. 8
R
1
1
3/8–18
npsm [R 3/8–19]
compound thread
B. Connect
the other end of the fluid hose (R) to
a regulated fluid supply line (U–see Fig. 9) or a
pressure tank (P–see Fig. 1, page 6).
NOTE:
Fig. 9 shows the fluid supply line regulator
(T) and fluid shut-of
f valves (Q).
R
T
02777
Fig. 9
U
Q