Filter
Top Products
Introduction
Great for all sheet metal forming, the Model
G0497 Planishing Hammer includes an integrated
filter/regulator and lubricator, and can shape mild
steel up to 16 gauge.
Inventory
Planishing Hammer ........................................... 1
Mounting and Setup
1. With the help of an assistant, carefully uncrate
the planishing hammer.
2. Determine the most suitable location for your
planishing hammer based on the planned
usage of the machine. Larger workpieces will
require a larger space around the planishing
hammer.
3. Mount the planishing hammer to the floor
using fasteners appropriate for the floor
type.
4. Check the oil level in the lubricator. If the oil
level is low, refill with an SAE 10-weight non-
detergent, non-additive oil.
5.
Install a male
1
⁄4" NPT quick connector fitting
into the air inlet of the planishing hammer.
Figure 1. Model G0497 Planishing Hammer.
MODEL G0497
PLANISHING HAMMER
INSTRUCTION SHEET
This machine presents
serious injury hazards
to untrained users.
Read through this entire
instruction sheet to
become familiar with
the controls and opera-
tions before starting the
machine!
The Model G0497 has a maximum operating
pressure of 120 psi. exceeding this maxi
-
mum can lead to high pressure parts failure,
which may cause serious personal injury!
INJURY HAZARD!
Disconnect tool from air and
power to prevent accidental
operation during service!
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
CRUSHING HAZARD!
Keep hands clear of hammer
mechanism at all times!
Machine Data
Control Power ...........110V, Single-Phase, 60 Hz
Blows per Minute .........................................
4600
Air Pressure ....................................... 90-120 PSI
Air Consumption ..................................... 12 CFM
Throat ............................................................. 24"
Weight ......................................................168 lbs