Filter
Top Products
"'%"
BdYZa<%*&+B[\#-$%+
3. >chZgi i]Z ZcY d[ i]Z YZVY XZciZg ^cid i]Z
iV^ahidX`WVggZa!Vhh]dlc^cFigure 18!jci^a
^i hZVih i^\]i Zcdj\] i]Vi ^i l^aa cdi gdiViZ
l]Zc ijgcZY Wn ]VcY# Note—do not worry
about pushing the dead center into the barrel
too far. The force of the center contacting a
mounted workpiece will fully seat the taper
when the handwheel is tightened.
4. I^\]iZci]ZWVggZaadX`idegZkZcii]ZiV^ahidX`
WVggZa[gdbbdk^c\Yjg^c\deZgVi^dc#
Figure 18.>chZgi^c\YZVYXZciZg^cid
iV^ahidX`WVggZa#
Adjusting Tailstock
Longitude Position
I]ZiV^ahidX`dci]ZBdYZa<%*&+XaVbehidi]Z
WZY l^i] i]Z cji h]dlc ^c Figure 19# I]^h cji
Vaadlhi]ZiV^ahidX`idWZedh^i^dcZYadc\^ijY^cVaan
Vadc\i]ZWZYVcYi]ZcadX`ZY^ceaVXZ#
To adjust the tailstock longitude position:
1. JhZ V&,bb lgZcX]id addhZci]Z iV^ahidX`
XaVbeWdai#
2. L^i]ndjg]VcYh!bdkZi]ZiV^ahidX`^cidedh^"
i^dcVadc\i]ZWZY#
3. I^\]iZci]ZiV^ahidX`XaVbeWdaiidhZXjgZi]Z
iV^ahidX`^cidedh^i^dc#
Figure 19.IV^ahidX`XaVbeWdai#
Removing Tailstock
Dead Center
To remove the tailstock dead center:
1. JhZi]ZWVggZa]VcYl]ZZaidbdkZi]ZiV^ahidX`
WVggZaVaai]ZlVnWVX`^cidi]ZiV^ahidX`jci^a
i]Z]VcYl]ZZal^aacdadc\Zgijgc#
2. Ejaai]ZYZVYXZciZgdjid[i]ZiV^ahidX`WVg"
gZa#