Filter
Top Products
-12-
G0528 Sliding Router Table
Cross Supports
Components Needed: Qty
Table Assembly ..................................................
1
Table Cross Supports .........................................
3
Rubber Stops .....................................................
2
Cap Screws
5
⁄16"-18 x 1
1
⁄2" ..................................2
Flat Washers
5
⁄16" ................................................8
Hex Nuts
5
⁄16"-18 .................................................4
Hex Bolts
5
⁄16"-18 x 1" .........................................2
Tools Needed:
12mm Wrench or Socket ....................................
1
6mm Allen Wrench .............................................
1
To attach the table to the stand:
1. Place the table assembly face-down on the
floor.
2. Position the table cross supports on the table
assembly and align the bolt holes (
Figure
5).
Figure 5. Table cross supports.
3. Secure bolt holes “A” (Figure 5) with 2 hex
bolts, 4 flat washers, and 2 hex nuts
.
4. Secure bolts holes “B” (Figure 5) with the
rubber stops, 2 cap screws, 4 flat washers,
and 2 hex nuts (Figure 6
).
Figure 6. Securing cross supports to table.
Bolt Holes “A”
Bolt Holes “B”