Grizzly G0528 Router User Manual


 
-16-
G0528 Sliding Router Table
5. Tighten the router clamps to secure the
router base into position.
Figure 14. Adjust the router clamp
thickness bolts.
Thickness Bolt
Jam Nut
Components Needed: Qty
Switch .................................................................1
Switch Box ..........................................................
1
Power Cord ........................................................
1
Strain Relief ........................................................1
Tools Needed:
Phillips Head Screwdriver ..................................
1
Adjustable Wrench .............................................
1
To attach the switch to the stand leg:
1. Install the strain relief on the outside of the
switch, using the plastic nut from the inside
to secure the strain relief to the switch box.
2. Feed the power wires through the strain relief
and tighten the strain relief screw against the
main cord jacket.
3. Secure the green ground wires from the
power cord and the switch box to the stand
leg, using the Phillips head screw and hex
nut already installed in the frame.
4. Push the switch through the cut-out on the
stand leg.
Switch
3. Loosen the router clamps enough to allow
the base of the router to press flat against the
underside of the cast iron table. Note—
The
router spindle should be centered under the
cut out in the cast iron table.
4. Adjust the thickness bolts and the jam nuts
on each of the router clamps to allow the
router base to be secured against the table
(Figure 14).