Filter
Top Products
Introduction
The Model G0625 Extension Table extends the
bed length of the Model G0624 10" Benchtop
Lathe to 38" between centers.
Inventory: (Figure 1)
A. Extension Bed ............................................ 1
B. Rubber Feet ............................................... 2
C. Cap Screws M8-1.25 x 35 .......................... 4
D. Flat Washers 8mm ..................................... 4
E. Hex Wrench 6mm ...................................... 1
Installation:
1. Install the feet into the bottom of the exten-
sion table.
2. Align the mounting holes in the extension
table and the tailstock end of the Model
G0624 bed.
3. Thread four cap screws with flat washers
through the extension table and lathe, and
finger tighten.
4. Center the tailstock over the extension table
and lathe as shown in
Figure 2.
5. Tighten the cap screws with the hex wrench,
to bring the bed extension and lathe surfaces
even with the bottom of the tailstock.
6. Slide the tailstock over the bed.
—If the tailstock catches on the area where
the lathe and extension table meet, loosen
the fasteners and repeat Steps 3-5
until
the tailstock slides smoothly.
MODEL G0625
BENCHTOP LATHE
EXTENSION TABLE
INSTRUCTION SHEET
Figure 1. Model G0625 inventory.
Figure 2. Tailstock centered over extension
table and lathe.
COPYRIGHT © NOVEMBER, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#BL8694 PRINTED IN CHINA
A
B
C
D
E
Model
G0624
Extension
Table
7. Place a straightedge over the extension table
and lathe beds and check to see if both are
parallel and aligned.