Grizzly G0658 Lathe User Manual


 


NOTICE: Only use tap screws or wood screws
with non-tapered heads (Figure 39) to attach the
faceplate to the workpiece. Do NOT use drywall
screws or screws with tapered heads because
these can split the faceplate, or the screws may
snap off during operation.
Figure 40.



2.        

3. 


4.       
      
       



To mount your workpiece to a backing block:
1.     Figure 40 
         

<DD9 769
Figure 39

       
  Figure 41     

Sanding / Finishing
Figure 41. 



HVcYeVeZg
Ldg`e^ZXZ
Wrapping the sandpa-
per completely around
the workpiece will pull
your hands into the mov-
ing workpiece and may
cause injury. Never wrap
sandpaper completely
around the workpiece!