Filter
Top Products
SKU 67024 For technical questions, please call 1-800-444-3353. Page 9
Note: Ni-Cd BATTERY MUST BE 10.
or open Battery Pack.
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION: Turn off tool and
remove Battery before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE: Do not use
damaged equipment. If
abnormal noise or vibration
occurs, have the problem
corrected before further use.
Cleaning, Maintenance, and
Lubrication
BEFORE EACH USE,1. inspect the
general condition of the tool. Check
for loose hardware, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical wir-
ing, and any other condition that may
affect its safe operation.
AFTER USE,2. wipe external surfaces
of the tool with clean cloth.
When storing, always store Impact 3.
Wrench in clean, dry and safe loca-
tion out of reach of children.
Troubleshooting
Problem Possible Causes Likely Solutions
Tool will not start. Battery not charged. Charge Battery.
Hammer function not
available.
Selector Ring in drilling position. Slide Selector Ring into hammering position.
Performance
decreases over time.
Accessory dull or damaged. Keep accessories sharp. Replace as needed.
Excessive noise or
rattling.
Internal damage or wear. Have technician service tool.
Overheating. Forcing tool to work too fast. 1.
Accessory dull or damaged. 2.
Blocked motor housing vents.3.
Allow tool to work at its own rate.1.
Keep cutting accessories sharp. Replace 2.
as needed.
Wear ANSI-approved safety goggles and 3.
NIOSH-approved dust mask/respirator while
blowing dust out of motor using compressed
air.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.