Filter
Top Products
SKU 95668 For technical questions, please call 1-800-444-3353 PAGE 13
Router Bit Assembly:
1. Prior to installation, make sure to remove any oil, grease, dirt and debris from
the Collet (103, 104), Draw Bar (121), and Spindle Housing (110) surfaces
before installing a Router Bit.
2. Remove the Spindle (105) as shown on page 12 of this manual.
(See Figures K, L, and M.)
3. Insert the Collet (103, 104) into the Spindle Housing (110). (See Figure N.)
4. Install the Router Bit (not included).
5. Hold the at edge on the Spindle Housing (110), and tighten the Collet Nut (102).
(See Figure O.)
6. Rotate the assembly by hand, making sure the Collet (103, 104) and bit rotate
freely on center.
7. WARNING! When using a Router Bit (103, 104), operate the Wood Shaper
only in a counterclockwise direction. Router Bits are designed to cut in the
counterclockwise direction only. DO NOT operate the Wood Shaper in the clock-
wise direction. If this warning is ignored, the workpiece can kickback. The Collet
Nut (102) can loosen and throw the Router Bit, causing severe injury.
SPINDLE HOUSING (110)
COLLET (103, 104)
FIGURE N FIGURE O
COLLET NUT
(102)
ROUTER BIT
SPINDLE HOUSING
FLAT EDGE
ADJUSTMENTS INSTRUCTIONS
1. CAUTION! Always make sure the Power Switch (5) of the Wood Shaper is
in its “OFF” position and the unit is unplugged from its electrical outlet prior to
performing any adjustment procedures.
Fence Positioning:
1. The two Fences (60) are independently adjustable to allow for different
(not included)
COLLET (103, 104)