Filter
Top Products
SKU 95668 For technical questions, please call 1-800-444-3353 PAGE 15
Table Inserts:
1. Table Inserts (53, 53A) are used to reduce wood chips falling into the machine
which could cause ying debris. Using the smallest Table Insert also covers any
unused portion of the bit below the surface of the Work Table (52).
(See Figure R.)
2. Position, and snap in the Table Insert (53, 53A) you wish to use. (See Figure R.)
3. Make sure the Table Insert (53, 53A) is seated and ush with the Work Table (52)
surface. (See Figure R.)
TABLE INSERT
(53, 53A)
WORK TABLE
(52)
FIGURE R
Belt Adjustment:
1. The Wood Shaper uses a Belt (123) on two Pulleys (113, 127) to compensate
for different Belt positions as the Spindle (105) height is adjusted. To adjust the
V-Belt:
Loosen the two Hex Head Screws (134). Slide the Motor (129) position to
increase or decrease V-Belt (123) tension, so that the Belt is snug with about 1/4”
deection when pressed lightly with your nger. Then, retighten the Hex Head
Screws. (See Figure S.)
V-BELT (123)
HEX HEAD SCREW
(134)
MOTOR (129)
FIGURE S