Harbor Freight Tools 90692 Lathe User Manual


 
3. The Cutting Tool (31) also can be adjusted
vertically
by loosening the Socket
Head Bolt (25) which secures the Tool Holder (24) in place. Once adjusted,
make sure to re-tighten the Socket Head Bolt. (See Figure H.)
4. The Cutting Tool (31) can be adjusted
horizontally
by moving the Tool Rest Base
across the Bed of the lathe, towards or away from the Spindle of the lathe.
(See Figure A.)
5. The Cutting Tool (31) also can be adjusted horizontally by loosening the two Set
Screws (20), moving the Cutting Tool in or out, and then re-tightening the Set
Screws. (See Figure H.)
To Perform Duplicate Turning:
1. Mount the
original woodstock that is to be duplicated
in the Pattern Bolts (42).
The Tool Rest Bases (44) will need to be adjusted along the Bed of the lathe to
the required length. (See Figures A, and C.)
2. Mount the new piece of woodstock in the lathe. When starting with a square
piece of woodstock that will be cut to a cylinder, detach the Spring (19) on the
Tool Holder (24) from the Support Bar (54). Manually feed the Cutting Tool into
the woodstock with a light depth of cut until the cylinder has been formed. Do
not start cutting on the end of the woodstock, as the Cutting Tool may
become caught and damage the woodstock. (See Figure F.)
3. Turn the woodstock to a cylinder slightly larger than final size. Then, reattach the
Spring from the Tool Holder (24) to the Support Bar (54) and adjust the Pattern
Follower assembly against the original woodstock. (See Figures E, and F.)
4. Continue gliding the Tool Holder (24) along the Support Bar (54) until the new
piece of woodstock fully duplicates the original piece of woodstock.
(See Figure F.)
5. Always make sure to turn off the lathe and unplug it from its electrical outlet when
finished with duplicate turning. Wait until the lathe and Lathe Duplicator Attach-
ment stop completely before attempting to remove the pieces of woodstock.
INSPECTION, MAINTENANCE, AND CLEANING
1. Before each use, inspect the general condition of the Lathe Duplicator Attach-
ment. Check for broken, cracked, or bent parts, loose or missing parts, and any
condition that may affect the proper operation of the product. If a problem
SKU 90692 PAGE 11