Filter
Top Products
SQUARE NUT (47)
SQUARE
NUT
(47)
SUPPORT BAR (54)
FLAT WASHER (40)
LOCKWASHER (34)
HANDLE (48)
FLAT WASHER
(40)
LOCKWASHER
(34)
HANDLE
(48)
FIGURE D
To Assemble The Tool Holder:
1. Loosen the two Set Screws (20) on the Tool Holder (24), and extend the Cutting
Tool (31) out about 4 inches. Then re-tighten the two Set Screws to secure the
Cutting Tool in place. (See Figure E.)
2. Slide the Pattern Follower Assembly into the T-Slot located at the bottom of the
Tool Holder (24). (See Figure E.)
SET SCREW (20)
.
.
CUTTING TOOL (31)
TOOL HOLDER (24)
PATTERN FOLLOWER
ASSEMBLY
T-SLOT
FIGURE E
SKU 90692 PAGE 8