Heath Zenith SL-5502 Work Light User Manual


  Open as PDF
of 4
 
595-5573-06
❒ Attach the cover plate to the junction
box (Apply silicon caulk between
cover plate and junction box for a rain-
tight seal). Keep the fi xture horizontal
(within +/- 4°) so the bulb inside is horizontal. If the bulb is not
horizontal, the bulb may darken or shatter and fail prematurely.
❒ Loosen the side bolt connected to the arm to aim the fi xture up
and down.
❒ For a rain tight seal, caulk the aiming arm joint with silicon
caulking compound.
Bulb Installation and Relamping
Important: Use a clean glove or cloth when handling the new bulb.
Oil from your hand may cause the bulb to crack when the fi xture
heats up and result in premature failure. Use isopropyl (rubbing)
alcohol to clean the bulb if it is touched with your bare hands.
❒ When relamping, turn power off and let the fi xture cool.
❒ Open glass cover and remove the old bulb by pushing the bulb
towards the right until the left side of the bulb is clear of the left
socket.
❒ To insert the new bulb push the bulb into the right socket so the
bulb is properly seated in the sockets.
❒ Re-install the glass cover.
❒ Reconnect the power.
Compact Twin 150 Watt Halogen
Fixture Installation Instructions
To avoid Electrical Shock:
Wiring Fixture
Connect all white
wires together
Connect all black
wires together
Model SL-5502
The Heath
®
/Zenith Compact Twin Halogen disperses light over a wide area. It includes two 150W halogen lamps, mounting plate
for standard junction box and is for use with 120VAC.
FOR PROPER INSTALLATION AND OPERATION, PLEASE READ THESE INSTRUCTIONS CAREFULLY.
To Avoid Fire or Burn Hazards:
• Allow fi xture to cool before touching. The bulb and the fi xture operate at high temperatures.
•
Keep fi xture at least 2" (51 mm) from combustible materials. Do not aim at objects closer than 3 feet (1 m).
•
Use up to 150 watt lamp maximum per lampholder.
+/- 4°
Junction box ground
wire to green ground
screw on fi xture
No Service Parts Available for this Product
Cover Plate
❒ Connect the lamp wires to the power source wiring. Secure with
wire connectors.
© 2007 HeathCo LLC 595-5573-06
WARNING: Turn power off at the circuit breaker or
fuse.
• Grounding and installations must comply with local codes and
the National Electric Code (Canadian Electrical Code).
• This product should be mounted on a grounded junction box and
must be used with a threaded cover plate.
• Permanently mount the fi xture to a building or pole. This fi xture
is for outdoor use and is wall and eave mountable.
next